Faucet and Fixture Repair in Concord
Shield Plumbing provides faucet and Fixture Repair in Concord, Cabarrus County, from our base in Landis.
- NC Plumbing License #37106
- Based in Landis, NC
- Residential & Commercial Plumbing
Concord is about 18 miles from our Landis base, roughly 25 minutes south on I-85. Call and describe the problem, and a licensed plumber will look at it in person. You get an estimate before any work starts.
Signs You Need Faucets and Fixtures
- A faucet drips after you turn it off
- The toilet runs or refills on its own
- Water pools under the sink
- The handle is stiff or hard to turn
- A shut-off valve will not close
If a faucet drips, a toilet keeps running or a shut-off valve is stuck, call Shield Plumbing about faucet and fixture repair. Call (980) 980-9219
How Long It Usually Takes
| Faucet repair | About 1 hourTypical for a new washer or cartridge. |
|---|---|
| Toilet repair | About 1 hourFlapper, fill valve or wax seal replacement. |
| Faucet or toilet replacement | 1 to 2 hoursDepends on access and the condition of the valves. |
Typical times, plus roughly 25 minutes of driving each way.
Faucets and Fixtures for Concord Homes
Concord is about 25 minutes south on I-85. In newer west side homes near Concord Mills, we replace worn builder-grade faucets and toilet parts. In older homes near downtown, we fit new fixtures to older pipe, which can take adapters and care around old walls.
Where We Work in Concord
- Downtown Concord
- Union Street
- Afton Village
- Christenbury
- Concord Mills area
- Poplar Tent Road
How the Job Works
Find the failed part
We check whether a washer, cartridge, seal or valve has failed.
Repair or replace
We tell you if a repair will last or a new fixture makes more sense.
Check the valves
We test the shut-off valves, since a stuck valve makes future repairs harder.
Test for leaks
We run the fixture, check every connection for drips, and clean up the work area.
Book Faucets and Fixtures in Concord
You get an estimate before any work starts.
What Affects the Price
| Repair or replace | A new part costs less than a whole new fixture. |
|---|---|
| Who supplies it | You can buy the fixture, or we can source the parts. |
| Valve condition | Seized shut-off valves may need replacing before the fixture. |
| Distance to Concord | About 18 miles from our Landis base, roughly 25 minutes south on I-85. |
Faucets and Fixtures Questions from Concord
Yes. Let us know the brand and model when you call so we can check that it fits your sink and supply lines. In older Concord homes, the old shut-off valves may need replacing at the same time. We tell you before we start if anything else is needed.
Call us and describe what you are seeing, where it is in the house and when it started. We will explain what the first visit involves and find a time that works. Before any work starts at your Concord home, you get a clear plan and an estimate.
Concord is about 18 miles from our base in Landis, roughly 25 minutes south on I-85. That puts it inside our regular service area. When you call, tell us your street and the problem so we can plan the visit and bring the right parts.
More than most people expect. A steady drip can add up to many gallons a week, and it shows up on your water bill. It also leaves mineral stains and can wear the sink finish. Most drips come from a worn washer or cartridge, which is a small repair.
Need Faucets and Fixtures in Concord?
We find the cause first, then give you a price.